About
a case that can be used for an iPod, cell phone, hard drive or anything else !
Easy to do project that requires minimal fabric, velcro, a button and a sewing machine.
-
Miss_Fit added I Pod Case to Purses, Bags, and Wallets
29 Mar 03:31
You Will Need
-
Step 1You need : two pieces of fabric and some bunting size 14x4, a square piece of velcro, a scrap piece of fabric for the design on the front and a button.
-
Step 2Sew the velcro on opposite pieces like shown in the picture. Also sew your scrap fabric to the fabric piece that the velcro is not near the edge. Add your button below the velcro on the same piece.
-
Step 3Place the pieces together with the bunting on top and the velcro facing in (the velcro pieces should be facing each other at opposite ends)
-
Step 4Sew around the edges leaving a small hole (the hole should be near the middle on either of the long sides) and then turn inside out and iron flat.
-
Step 5Fold the bottom up 3/4 of the way and sew up each side making sure you closed the hole. Make sure your velcro pieces match up before you sew up the sides.
-
Step 6Fold the top over and iron the flap down.
Finished !
Comments
