i based the project on an old earring i had.
i wanted my new earring to be a little bigger than the original one (as u can see in the picture).
when you cut make sure that one side is longer than the other.
you should cut another hoop now to mach the other earring later...
its hard to explain but I'll try:
what you do now is a little circle ,then you bend it to a "u".
if you didn't get it keep looking at the pictures or-
u can skip this step and just hope the earring wont fall out:)
if u succeeded step 4 good job!now put it on aside.
take you bead and put a little glue on the bead and spread it with your fingers (quickly its fast glue!!) now wrap the lace around the bead but not on the hole!
it turns out like this :)
take your wire and cut a piece as long as half a the length of your little finger.
now thread it throe the bead,and twist the one end.
turn the other end into a little hoop.
now just thread the little hoop in the earring u made at step 4.
hope u like it!!