Handmade Necklaces Out Of Pearl And Safety Pins

  ✂︎

Favorite

Comment

List

       

Share

• 

  Step 1

  Step 1: Make the focal pendant

  1. Cut 2 pieces of wire, about 15cm and 30cm long respectively;

  2. Take the shorter piece and loop one end with pliers;

  3. Thread three safety pins onto the loop on wire;

  4. Take the longer wire and loop the end as before;

  5. Pass the wire through the safety pins while inserting one pearl bead between each safety pin;

• 

  Step 2

  6. Keep adding safety pins and supplying pearl beads between them. When the half part has reached your desired length, stop to make the second piece.

  7. Make a smaller loop at end and wrap the leftover wire tails around the last exposed wire. Do the process at all four locations.

• 

  Step 3

  Then, you will get two components as below.

• 

  Step 4

  Step 2: Add on the chain

  1. Place the two components on a flat surface as picture shows;

  2. Attach the chain using two jumprings at the top;

  3. Connect the two bottom parts with a jumpring. Finally, hang on a spike pendant for decoration in the middle.

  This is what the final product looks like.

Comments

Leave your comment