1. 1
   

   Start by placing the hama beads on the board. You could use any colors but I have chosen sparkly clear for the icing with a red cherry on top.

   Place a bit of greaseproof paper over them and press on them with a hot iron (no steam!) for about 20 seconds or so. I think I did mine for a little too long as the paper stuck to the back on the top :(

   
   
2. 2
   

   Get together your supplies. I was going to do something else so put some gold beads in the photo but by the time I decided not too I had made one earring so couldn't re-take the photo.

   
   
3. 3
   

   If, like me, the top snapped off one then get a larger jump ring or wrap some wire around a pencil and snip it off to make a larger jump ring. Poke this through the top red and the middle top white and close it with the pliers.

   
   
4. 4
   

   For the other, un-snapped one I just put a normal jump ring through the top hole and through the hole in the earring wire. Close up the jump ring.

   
   
5. 5
   

   TA_DAA! A finished, very cute, pair of earrings :)

   
   

Have you made this project? Share your version »