About

Cost
$ $ $ $ $
Difficulty
• • • • •
Time
20 mins

Make sure everyone knows which wine glass is theirs with this adorable fringe name tag.
Making these for my sister's baby shower was tons of fun and was a cute way to label each wine glass. Plus everyone loved seeing their name surrounded in fringe!

Posted by SquirrellyMinds from Victoria, British Columbia, Canada • Published See SquirrellyMinds's 7 projects »
PrintEmbed
  • How to make a glass. Fringe Wine Glass Name Tags - Step 1
    Step 1

    Cut kraft paper into strips 8.5 inches long and 3/4 an inch high. Fold in half, line up edges, and cut a ribbon point (two points on each side) on the end.

  • Step 2

    Cut a piece of crepe paper 3 3/4 inch wide and however long the paper is. Fold in half multiple times until it is about 1.5 inches high. Cut along the folded edge so you now have multiple 3 3/4 x 1.5 inch strips.

  • Step 3

    With your fringe scissors or by making multiple vertical cuts, cut fringe along each length of your crepe paper, leaving a 1/4 inch margin in the centre. Take one strip, bead a line of white glue in the centre and place another strip on top. Do this two more times so you have four pieces of fringe crepe paper strips glued on top of each other.

  • Step 4

    Place a piece of double sided tape on one side of the inside of your kraft paper and stick the crepe paper on, making sure you have an even amount peeping above and below the kraft paper (about 1cm). Stick another piece of double sided tape on top of the crepe paper, but leave a 1/2 inch margin by the fold. You don’t want double sided tape on your wine glass. Don’t remove the tape cover just yet.

  • Step 5

    Using a fancy pen (I went for white ink calligraphy), write each guests name on a strip. Make sure the fold is on the left side, otherwise it will be upside down when you put it on.

  • Step 6

    Only do this step when it’s almost party time and you’re ready to decorate your wine glasses. Place the name tag’s fold right against the bottom of the glass stem and remove the double sided tape cover.

  • Step 7

    Align the ends to ensure the points meet up, then press the kraft paper against the tape on the crepe paper to seal your name tag. Voila! Fringerrific!

Made this project? Share your version »

Comments

More Projects