Add to Favorites Add Your Version

1. 

   Get all your supplies together. Using the flat glass stone as a template trace the chosen image for your ring. Once cut out glue it to the back of your stone using mod poge matte. Put it to the side.

2. 

   Get your two pieces of 12 in. wire, put them side by side and treat them as one. Using a ring mandrel or fat marker close to your ring size, wrap the two wires around and then twist them around eachother like you would a bread tie.




3. 

   Now your stone with the image would have dried. Place the stone right over the twisted part of the wire holding it down with one hand and with the other, begin wrapping the wires aroung the stone until its secure. Try not to cover the image with the wires too much. Snip the ends and curl them in. Hope my directions were clear. Have fun.

See more Jewellery Making or Retro