First print out the image from your computer

You could also find a pic in a magazine

Cut out the image

Roll out your polymer clay flat about 1/4 inch thick

Place the cut out image on top of your flattened clay

Using the paper image as a stencil, carefully cut it out of the clay with the xacto knife

Remove the paper stencil and smooth out any rough edges

Make a small hole at the top for the jump ring to go through

Bake for about 30 minutes

After it has cooled off, apply about 3 layers of the clear glossy varnish to the front and sides

After the varnish dries, add the jump ring and necklace chain

If you want, glue on some pyramid studs to fancy it up