Make and Share Craft Tutorials
About
Published
over 1 year ago
Time
Difficulty
Posted By
I have kinda stubby hands so I've learned that when gloves are too big for me, the easiest thing to do is cut off the fingers. I recently got a large collection of gloves that once belonged my fiance's grandmother. Most of them fit me perfectly but a few pairs were a bit to big. They looked like they had never been used so I guess they were too big for her too. I saw cut-out gloves in the Chanel spring 2011 rtw show and became immediately obsessed. I finally got around to making my own.
Tags
Crafts
Instructions
You Will Need
- Unlined vintage leather Gloves
- Scissors
- An X Acto Knife
- Two pieces of Cardboard or heavy cardstock, one cut to fit inside the palm of the glove and one cut to fit inside a finger of the glove
- Hot Glue Gun
- Project Cost
- Cheap
-
1
Things you need for this DIY:
-
2
First I turned the gloves inside out and marked with a pencil where to cut the bottom off, leaving a quarter inch seam allowance. You can kinda see.
-
3
Then I chopped em and hot glued the edge over.
-
4
I cut off the fingers without measuring but I put them on before I glued the edges to make sure I had cut enough off. You wanna leave yourself about an 8th of an inch extra.
-
5
I glued the finger edges in four steps to make it easier; front, back, side, side.
-
6
I used pencil to draw rectangles on the back of the glove.
-
7
Here's the tedious part, cutting the rectangles out with the X-acto knife.
-
8
Then I turned them inside out and was good to go!
Enjoy!
Comments
Recent Favorites
