Cabochon Photo Bracelet

  ✂︎

Favorite

Comment

List

       

Share

• 

  Step 1

  Print out your aimed images in the size of the setting. I had to re-cut mine a little.

• 

  Step 2

  Glue them into the setting and DON'T USE TO MUCH GLUE! Only a little! Because otherwise the paper will get wet and that destroys the image.
  Lots of danger here like I told you.

• 

  Step 3

  Now the hardest part.
  Drip a ball of glue in the center of the pic, then gently (!) press the cabochon on it. No rubbing or stuff! Just leave it alone then.

  And after some time, you can look at it again. In the best case no bubbles are there then, but they might appear. In the worst case they're in a person's face.... and you have to start again.

Comments

Leave your comment

Dianita C. · Bogota, Bogota, CO 16th December 2012

the idea is great, Iwould try whit my photos

Anna H. · Kassel, Hesse, DE · 243 projects 16th December 2012

thanks post your version if you do!

Reply

Zombicology · Harrisburg, Pennsylvania, US · 6 projects 16th December 2012

You would probably have better results if you used photo paper, rather than copy paper! Also, you could print them off normally, then take them to a Staples, or Kinkos and have them laser printed, so the picture wont bleed. Its only a few cents per sheet last I looked, and it would work/look much better!

Anna H. · Kassel, Hesse, DE · 243 projects 16th December 2012

I went to the copyshop and it was laserprinted ;) and photo paper won't help me avoid bubbles... but thanks

Zombicology · Harrisburg, Pennsylvania, US · 6 projects 17th December 2012

Ahh okay! <3

Reply