Cut approximately 12cm of wire, thread on a bead of your choice, bend the wire in half and gently twist the wire loosely together. Repeat to make 20 strands. Use a Swarovski crystal and a 4mm pearl on four strands and single beads for the others.

Start in the middle of the tiara band, wrap the ends of one strand tightly around the band Use the flat part of the
pliers to flatten any sharp pieces of wire.

Repeat for all of your twisted wires, Work out from the centre keeping them close together. You can trim some of
the wires to make a variety of lengths for the decorated section.

This is what your finished tiara should look like.