Following on from my Batman and Robin bats, here's the Villains series! Sorry there's not photos like Batman, but go check him out on my page for clear shots cos the process is the same :)
The basic body:
Using a 3.5mm (E) hook, CH2/ magic ring in black.
Round 1: 6sc into centre of 2nd stitch from hook/ magic ring 
Round 2: INC around 
Round 3: [1sc, INC] Repeat around 
Round 4: [2sc, INC] Repeat around 
Round 5: Sc around 
Switch to grey
Round 6 – 7: Sc around 
Round 8: [2sc, DEC] Repeat around 
Round 9: [1sc, DEC] Repeat around 
Round 10: DEC around 
Switch to peach
Round 11: INC around 
Round 12: [1sc, INC] Repeat around 
Round 13: [2sc, INC] Repeat around 
Round 14 – 16: Sc around 
Round 17: [2sc, DEC] Repeat around 
Round 18: [1sc, DEC] Repeat around 
Round 19: DEC around 
Finish off, stuff firmly and sew the hole closed.
Row 1: 6sc (start in second chain from hook).  Ch1 turn
Row 2: DEC, 2sc, DEC  Ch1 turn
Row 3: DEC, DEC,  Ch1 turn
Row 4: DEC 
SL ST around the whole of the outside (I think it was around 12 sl st, but I can’t honestly remember! Do as many as you need to). Finish off leaving long tail for sewing, and attach to the face with the top point just above the centre.
To make the mask straps, ch approx 15 to go around the head horizontally and sew in place. Ch approx 12 to go over the head vertically (I say ‘approx’ because your head may turn out bigger/ smaller than mine, so try before you stitch!).
Sew on eyes using black wool/ embroidery thread.
His wings are brown felt (like his coat in the film - I was going to add a cream lining but I didn't have the felt)