DIY Charging Station

Add to a List Add to Favorites Add Your Version

You Will Need

- Project Budget
- Cheap

Time:2h00

So-so

Description

Last night I got the creative bug, and whipped together this pink and brown padded charging station for my new phone and iPod. I got the idea to use a pre-made box from this tutorial and was just waiting to find the right box to use. I made it from two of these Martha Stewart Coffee Bean Specimen Boxes. The are originally $9.99, but I found them at my local Michael's store for only $2 each!

Instructions

1

HOW I DID IT:

The boxes have a thick plastic covering the opening, so I first removed the plastic from only one of the boxes. I slid my blade just in between the plastic and the box along all sides to loosen the glue, and it popped right out.
2

Then I pulled out the padding inside, turned it over and cut a long narrow opening, wide enough for the adaptor ends of my cords to fit through.
3

I also removed the pink ribbon on the back. That is my top box.
4

The bottom box I also ripped out the padding and removed the ribbon from the back.
I cut a matching opening in the bottom

And on the opposite side of the bottom box, I punched 3 holes for my cords to run through. After punching the holes, I made a slit from the hole to the edge of the lid with a razor blade, so that the cord can be pushed through the slit into the hole, and it will only look as if the cord is running through the hole itself.
5

Next I used craft glue to glue the two boxes bottom-to-bottom, lining up the narrow openings
6

And ran my cords through the bottom box and
7

up through into the top box.
8

I replaced the padding in the top box, leaving just the adaptors peeking over the edge.
9

And that was it! Remember that I took out the plastic on this top, so I can just reach in and plug in my phone or iPod and let it rest on the pink padding!